“ULTRA” MAGNETIC BLOCK

Both side can hold work pieces & can be turn ON-OFF individually
They are shear to the work table by turning ON-OFF magnet
the side face can also hold work piece.
Light weight for easy positional adjustment.
Removable ON-OFF handle.
Suitable for grinding machine & EDM machine.
 
Sr. No.  Cat No. Size (mm)
1. UL-61101 150 L x 50W x 50H
 
“ULTRA” STAINLESS STEEL EDM VICE

MADE FROM STAINLESS STEEL
Useful for holding purpose on wire cut machine.
Suitable for mounting on machine belt.
Suitable for round job.
Hardness 55 ± 2 Rc.
 
Sr. No.  Cat No. Size (mm)
1. UL - 31601 270 L x 22W x 145H
 
“ULTRA” UNIT VICE

Useful for holding purpose on drilling machine & CNC machine.
Made from alloy steel.
Hardness 60 ± 2 Rc.
Suitable ferrous & non ferrous material.
 
Sr. No.  Cat No. Size (mm)
1. UL - 31801 200 L x 60W x 90H
2. UL - 31802 400 L x10W x 120H
 
“ULTRA” MAGNETIC PLATEN - NEW

Introduction:
Ultra Magnetic Platen used for very fast, safe & easy clamping of moulds on Injection moulding machine. This advanced 
technology eliminates hydraulic & mechanical clamping system & provides quick mould change (QMC) and just in time (JIT) moulding.

Operating Principal
Magnetic Platen works on the ELECTRO PERMANENT MAGNETIC SYSTEM that develops very high magnetic force. 
The electrical control equipment is only to activate & de-activate the magnets inside the platen i.e. it will not loose it's 
magnetic power in case of power failure. It doesn't requires power once it is magnetized.

Operation
To mount a mould, the operator has to match the mould base to the locator ring on stationery platen, then bring the 
moving platen in until it touches the rear mould plate. Now, the operator has to magnetize the mould, remove the straps
holding the mould halves together and then pull the moving platen back. The machine and mould are now ready for
production.
A typical magnetic mould change involves bringing both mould halves together, securing the mould halves; 
demagnetizing the platen & then lifting the mould out of the press by suitable means.

Universal :
Compatibility with all existing machines
Full utilization of active area of the platen
Maintenance Free
Saving:
Drastic reduction of downtime
Virtually zero operating cost, no power consumption
Very fast return of investment

Reliable :
Total demagnetization of moulds & plates when switched off.
No deformation
Fast Clamping

Safe :
Working on ELECTRO PERMANENT MAGNETIC SYSTEM
Uniform clamping force across the entire rear of mould
Uniform magnetic field.
Sr. No.  Cat No. Size (mm) Max. working temp. Clamping Force (Kg/Cm2) Thickness
1. UL21001  Depends on Machine Platen Size 0 -130 25 - 30 60 - 65 mm
2. UL21001  Depends on Machine Platen Size 130-240 25 - 30 60- 65 mm
3.

ULTRA CONTROL UNIT FOR ABOVE MAGNETIC PLATEN

.

| Home |